Mark Levinson N 326S - Manual (Page 15)

1-7
Nº326S Preamplifier Getting Started
5. Insert two AAA batteries as shown in the illustration to the
left. Make sure the batteries are correctly inserted observing the
proper polarity.
6. Align the battery compartment cover with the guide on the
back of the remote control.
7. Replace the three screws that were removed in step 2.
8. Properly dispose of the old batteries (if applicable).
Power Requirements
The Nº326S can be powered with a standard 15amp AC power
line. If other components are also connected to the AC power
line, the combined power requirements of all components should
be considered.
When shipped, the Nº326S is configured for 100, 120, 220, or
230VAC power operation at 50 or 60Hz. In compliance with CE
regulations, the Nº326S is configured for 230VAC power operation
at 50Hz in European Union countries. Before operating the Nº326S,
make sure the ~ac mains connector label indicates the correct
operating voltage for the current location.
CAUTION
• DO NOT ATTEMPT TO ADJUST THE OPERATING
VOLTAGE. CONSULT AN AUTHORIZED MARK LEVINSON
DEALER IF THE OPERATING VOLTAGE IS INCORRECT
OR IF THE OPERATING VOLTAGE MUST BE CHANGED
FOR RELOCATION PURPOSES.
• BE ADVISED THAT DIFFERENT OPERATING VOLTAGES
MAY REQUIRE THE USE OF DIFFERENT POWER CORDS
AND/OR ATTACHMENT PLUGS. CONTACT AN
AUTHORIZED MARK LEVINSON DEALER FOR
ADDITIONAL ASSISTANCE.
Warm-Up & Break-In Although the Nº326S delivers superior performance from the first
Period time it is powered on, this performance will continue to improve
as the Nº326S reaches its normal operating temperature and
various components “break in.” The greatest performance
improvements will occur within the first 25 to 50 hours of use.
Sound quality will continue to improve for about 300 hours.