Mark Levinson N 326S - Manual (Page 34)

• DO NOT use remote controls for different components at
the same time. Remote controls for different components can
interfere with one another.
Command Overview Unless otherwise specified, the numbered items in this section
indicate the commands the remote control performs during normal
operating mode. Refer to Section 3: Setup Menu and Section 4:
Controls & Modes for information about other commands the
remote control performs.
1. IR transmitter
Sends infrared signals to the front panel display IR receiver
when the Nº326S is not using the rear panel ir input connector.
Refer to Operation Considerations (previous page) for additional
information.
2-16
Basic Operation Mark Levinson
standby
PREAMPLIFIER
Nº 326S
enter setup
polarity balance display mono
mute
volume select
+
–
2
3
6
7
8
10
11
9
5
4
1