1 typical current profiles, 2 conducted noise, 3 voltage tolerance – Maxtor DIAMONDMAX 100462887 User Manual
Page 20: Figure 1, Typical 5v startup and operation current profile, Figure 2, Typical 12v startup and operation current profile
12
DiamondMax 20 Serial ATA Product Manual, Rev. A
2.8.1.1
Typical current profiles
Figure 1. Typical 5V startup and operation current profile
Figure 2. Typical 12V startup and operation current profile
2.8.2
Conducted noise
Input noise ripple is measured at the host system power supply across an equivalent 80-ohm resistive load on
the +12 volt line or an equivalent 15-ohm resistive load on the +5 volt line.
• Using 12-volt power, the drive is expected to operate with a maximum of 120 mV peak-to-peak square-wave
injected noise at up to 10 MHz.
• Using 5-volt power, the drive is expected to operate with a maximum of
100 mV peak-to-peak square-wave
injected noise at up to 10 MHz.
Note. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write
current.
2.8.3
Voltage tolerance
Voltage tolerance (including noise):
5V ± 5%
12V ± 10%