Multiquip Mikasa Vibratory Walk-Behind Roller MDR-9DYE - Manual (Page 23)

MQ-MIKASA MDR-9DYE VIBRATORY ROLLER — PARTS & OPERATION MANUAL — REV. #0 (12/19/03) — PAGE 23
LIFTING
1. Use a crane or lift to load and unload the machine. A
skilled crane operator is required to perform the job.
2. When lifting the machine, check for any damaged or
loose bolts, lifting hooks, and shock mounts.
3. Check any damaged or loose bolts in the guard frame to
avoid machine sliding off.
4. Make sure that the machine is shut off before machine is
lifted.
5. Use reliable cable for lifting.
6. Always lift the machine vertically and keep the
machine away from workers and animals.
7. Do not lift the machine higher than the required
height.
TRANSPORTING
1. Always make sure that the machine is shut off while
being transported.
2. Check that the fuel cap is properly closed and
tightened.
3. When traveling long distances or on rugged terrain,
drain the fuel of the machine before transporting.
4. T i e d o w n t h e m a c h i n e s e c u r e l y o n t h e
transportation so that it will not move or topple over.
MDR-9DYE — OPERATION
STOPPING
1. Place the vibrator and travel levers to the neutral position.
2. Slow down the engine and allow to cool for at least 2
minutes. In an electric start, return the key switch to
the STOP position as soon as the engine stops.
3. After the engine stops, close the fuel cock.
4. The hydraulic brake is automatically engaged when the
travel lever is in neutral position. When parked on a slope
with the engine turned off, place a block against the
roller drum to prevent the roller from moving.
CAUTION :
Neglecting to return the key switch to the
STOP position will cause the battery to
discharge, making start-up impossible the
next time.
UNLOADING
1. If you need to move the roller by pushing it manually
once engine is stopped, push in the upper and lower
knobs of the transmission check valve. This will
cause the hydraulic break to disengage and allow
the roller to be moved without causing damage
(Figure 24).
2. After moving, reset upper and lower knobs.
NEVER tow roller with any type of vehicle.
Doing so will damage the hydraulic system.
NEVER perform unloading procedure on a
slope. This may cause roller to roll down if
parking brake or blocking is deficient.
CAUTION :
Figure 24. Disengaging Hydraulic Brake