Miller Electric MSC-2 - Manual (Page 11)

OM-1096 Page 7
SECTION 3 – INSTALLATION
3-1. Location
IMPORTANT: Mount slide so motor and cables are away from weld zone to protect from heat and spatter.
The motorized slide is normally installed onto the cross arm of a side beam opposite the side beam control. An adapter
plate is available. The MSC-2 is normally installed behind the side beam control on the cross arm. Brackets are
available.
3-2. Interconnecting And Power Cord Installation
Ref. ST-154 578 / ST-098 878-B / Ref. ST-154 602
1 Motorized Slide
2 MSC-2 Control
3 Interconnecting Cord Plug
4 Receptacle
Align keyways, insert plug into
receptacle, and tighten threaded
collar.
5 115 Volts Ac Plug
Connect plug to matching
grounded and protected (time delay
fuses or circuit breakers) 115 volts
ac receptacle.
1
2
3
4
5
3
3 4
RIGHT-LEFT UP-DOWN