Magnadyne EXTREME X7 - Manual (Page 4)

The X7 is equipped with an optional automatic arming feature, which allows the security system
to automatically arm itself 30 seconds after the last door is closed.
1. Turn “OFF” the ignition key and exit the vehicle.
2. After all entrances are closed, the security system LED will flash fast for 30 seconds. If you
re-open any protected entrance, the security system LED will stop flashing. It will begin
flashing again when the vehicles entrances are closed.
3. After the 30 second timer has elapsed, the security system will automatically “Arm”. The
siren will chirp once and the parking lights will flash once.
Automatic Arming with Automatic Door Locking: (Additional Option)
With this option active, the vehicle’s doors will automatically lock after the automatic arming
cycle has been completed.
Automatic Arming Bypass:
While the LED is flashing for automatic arming or automatic re-arm, press the button twice,
the security system will respond with 1 chirp and LED will turn “On”. The security system will
remain in this temporary state for as long as you wish. To exit passive bypass, press the
“Lock” or “Unlock” button and the system will return to normal status.
Note: While in Automatic Arming Bypass mode, you will be required to manually arm you
system. Following the “Manual Lock/Arm” procedure above.
Using The Transmitter To Lock/Arm The Security System
1. Press the button on the transmitter.
2. The horn and parking lights will chirp/flash once indicating that the system is now armed.
The vehicle’s doors will lock upon arming when interfaced with the security system.
Silent Arming/Disarming:
Pressing the button on the transmitter will arm or disarm your security system, no chirp
sound will be heard, arm/disarm confirmation will be through the vehicles parking lights only.
Defective Sensor Reminder:
If the siren chirps 3 times, you have left open a hood, door or trunk.
Shock Sensor Optional Sensor By-Pass:
Press the button once, the siren chirps once, the security system is now armed. Press the
button a second time within 5 seconds, the siren chirps twice, the shock sensor is now
bypassed. The sensor bypass feature is programmed to activate for one arming cycle only. The
security system will return to normal operation during the next arming cycle.
+
Security System Operation
4
Manual Lock/Arm
Automatic Arming (Optional)