Mamiya 7 II - Manual (Page 12)

Mounting/Removing Lenses
Closing the light shield curtain
Removing camera body cap
1. Cock the wind-up lever.
After cocking the shutter, close the light shield curtain.
2. Close the light shield mask.
Set upright the light shield curtain closing lever handle
“A” and turn it from the open position (
) following
arrow direction and fit the white index line on the lever
to the closed position, the light shield curtain will be
closed. After the motion, bring down the light shield
closing curtain lever handle
.
*The light shield curtain closing lever is ratchet
type. Do not stop turning without going all the
way. Be sure to turn until it clicks and stops.
If your finger is removed from the light shield
curtain closing lever immediately before its
stopping, it sometimes return to its original
position.
If the lever is brought halfway and left, the lens
removing button cannot be pressed.
While pressing the lens release button “A” in, rotate the
cap counterclockwise, and align the groove “B” on the
cap's side with the lens alignment dot “C” on the body.
The body cap can then be pulled out.
10