Cleaning solutions, Cleaning the fingerprint reader – Motion Computing F5 User Manual
Page 62
56
Chapter 4
Care and Maintenance
Cleaning solutions
Motion Computing maintains a list of tested cleaning solutions and chemical disinfectants
on the Motion Computing web site. To access the list, follow the instructions provided
below for your tablet PC.
For the C5 Tablet PC:
1. Go to
2. Click the standard cleansers link.
For the F5 Tablet PC:
1. Go to
2. Click the standard cleansers link.
WARNING:
Do not use any solution that is corrosive or abrasive to clean or disinfect the
tablet PC.
If you are concerned whether a cleaner or disinfectant will harm your tablet PC, contact
Motion Computing support.
Cleaning the fingerprint reader
Under normal circumstances, you should clean the fingerprint reader once a month, or
whenever necessary.
To clean the fingerprint reader
1. Shut down the system, unplug it, and remove the battery.
2. Lightly spray a cotton swab with household window cleaner.
3. Gently rub the sensor surface with the cotton swab, slowly rotating the swab so a new,
clean surface of the swab is constantly exposed to the sensor surface. Do not allow
cleaner to drip or run down into the electronics around the sensor.
Do not use bleach, solvents, or abrasives. Do not spray or pour any liquid directly on the
sensor.
4. After cleaning, gently rub the surfaces again with a clean, dry cotton swab. Use a clean
swab each time you clean the sensor.