Motorola DIGITAL VOICE MODEM SBV5122 - Manual (Page 14)

B
SBV5122U Cabling Instructions • SBV5122 Rear Panel
6
SBV5122 Digital Voice Modem • Installation Manual
568756-001-b
3
Cabling and Powering Up the SBV5122
CAUTION This product is for indoor use only. Do not route the USB, Ethernet and/or
telephone cables outside of the building. Exposure of the cables to lightning could create a safety
hazard and damage the product.
CAUTION Contact your service provider before connecting your digital voice modem to
existing telephone wiring. DO NOT connect the telephone wire to a traditional telephone (PSTN)
service.
SBV5122U Cabling Instructions
1. Insert the CDROM into your computer to load the USB driver.
2. Connect one end of the coaxial cable to the cable outlet.
3. Connect the other end of the coaxial cable to the cable connector on the modem.
4. Insert the power cord into the power port on the modem.
5. Plug the other end of the power cord into an electrical outlet.
6. Insert one end of the USB/Ethernet cable into your computer.
7. Insert the other end of the USB/Ethernet cable port on the modem.
8. Insert one end of a telephone cable into the Tel 1/2 or Tel 2 port.
9. Connect the other end of the telephone cable to a telephone (to make or receive calls active
VoIP service is required).