MITSUBISHI ELECTRIC EN-1 - Manual (Page 11)

EN-11
1 Enter “9” and press the Enter key.
2 The setting screen is shaded and the setting process
completes.
Save and exit
• Because the password, display language, LAN control, and PJLink ™ certifi cation are set using the telnet function,
you can also set them on the command prompt window of the personal computer. Enter the following command and
press the Enter key.
> telnet IP address you set 9999
[“>” shows a prompt.]
When setting menu appears, perform the setting procedure as described above.
(Note 3)
Check that the port number “9999” isn’t blocked by the fi rewall.
Preparation/SetUp (continued)