Multiquip Mikasa Reversible Plate Compactor MVH-702DRSC - Manual (Page 15)

MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03) — PAGE 15
MVH-702DRSC — COMPACTOR COMPONENTS
Figure 3 illustrates the location of the major components for the
MVH-702DRSC Reversible Plate Compactor. The function of
each component is described below:
1. Monitoring Lights – Indicates if there is any failure in the
machine. There are four monitoring lights:
Receiving Failure Light
Oil Pressure (Engine) Failure Light
Regulator Failure Light
E/G Overheat Light
2. Lifting Hook Lever – Used to lift the machine.
3. Rubber Bumper – Protects the machine in case of bumps.
4. Extension Plate – Removable when not needed.
5. Hydraulic Motor – Drives all the operation of the machine
such as speed control, forward-reverse switching motion,
and steering as well as the vibrator unit on the base.
6. Rear Cover - When lifted, allows access to the monitoring
lamps, valve unit, block diagram and owner’s manual.
7. Receiver and Receiving Lamp –Receives infra-red
signals from the transmitter indicated by the flashing light
on the receiving lamp.
8. Fuel Tank/Cap – Fill with diesel fuel. Fuel tank holds
approximately 2 gallons (7.5 liters). DO NOT top off fuel.
Wipe up any spilled fuel immediately.
9. Front Cover - Allows easy pre-operational check and
refueling.
10. Valve Unit – Electromagnetic and hydraulic valve: controls
traveling speed and direction.
11. Oil Tank – Fill with proper grade of diesel engine oil.
12. Vibrator Oil Drain - Allows easy draining of vibrator oil.
13. Reciever - Located inside the compactor. Recieves signals
from portable transmitter durring remote operations.
14. Transmitter - Transmits operational signals to compactor
via the onboard receiver durring remote operations.