MicroNet Technology ELITE E36ODGPE - Manual (Page 5)

5 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Periodically (After the Burning Season)
Maintenance Task Accomplishing Person Procedure
Cleaning Firebox Interior
Replace Spent Batteries
Homeowner
Homeowner
Carefully remove logs and decorative volca-
nic stone. Vacuum out interior of the firebox.
Clean firebox walls and log grate. Replace
logs, Rockwool and volcanic stone as de-
tailed in this manual.
Locate and remove the four (4) screws retain-
ing the stainless J-Box cover. Remove the
battery pack and replace the two (2) "D" cell
batteries.
Maintenance Task Accomplishing Person Procedure
Inspecting/Cleaning Burner, Logs
and Controls
Inspecting/Cleaning Pilot and Burner
Appliance Checkout
Replacing Rock Ember Materials
Replace Spent Batteries
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Homeowner/Qualified Services Technician
Homeowner
Inspect valve and ensure it is properly operat-
ing. Check piping for leaks. Vacuum the
control compartment, fireplace logs and burner
area.
Refer to Figure 7 (Dexen) on page 8. Remove
any surface build-up on pilot and burner assem-
bly. Wipe the pilot nozzles, ignitor/flame rod and
hood. Ensure the pilot flame engulfs the flame
sensor as shown.
Perform the appropriate appliance checkout
procedure detailed in this manual.
Remove old ember materials and vacuum the
rock placement area. Place new rock as de-
scribed in this document.
Locate and remove the four (4) screws retain-
ing the stainless J-Box cover. Remove the
battery pack and replace the two (2) "D" cell
batteries.
Maintenance Schedule
Annually (Before the onset of the Burning Season)