Marvel Industries 6CiM - Manual (Page 4)

STEP 4: DETERMINING DOOR SWING
The door you received is for a right hand swing unit. If the
unit is to be changed to a left hand swing door, pre-drilled
striker plate holes are in place on the backside of the door
on both ends (see Figure 3). No additional drilling is nec-
essary to mount the striker plate when you reverse the door
swing. Just unscrew the striker plate from the location it is
mounted to for right hand swing and then mount the striker
plate at the end opposite of its previous location with the
existing screws.
If your door has an inner door liner with formed in shelves,
it will need to be turned around for use in the left hand
swing. Using a small, flat blade screwdriver, pop the plas-
tic screw covers up to access the Phillips screws that secure
the formed door liner to the door. Using a Phillips screw-
driver, remove the Phillips screws that secure the formed
door liner to the door. Rotate the formed door liner 180
degrees, line up the mounting holes in the door liner with
the mounting holes on the door. Use the existing fasteners
and plastic screw caps to secure the formed door liner to
the door. Your door swing conversion is complete.
FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
Figure 4: Striker Plate Hole Location
Holes for screws to mount striker
plate are already pre-drilled at
factory.
Striker Plate for Plunger Light
Switch New Door Bottom
for Left Hand Swing
Door
Remove the nameplate for the glass door by gently pulling
it up and away from the glass surface. Relocate the name-
plate using the supplied nameplate locator (part number:
41006022).
Figure 5: Nameplate Locator
2.38
3