Marvel Industries 6CiM - Manual (Page 5)

FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
STEP 5: ATTACHING THE OVERLAY PANEL TO THE
DOOR (WITH THE LOCK AND KEY FEATURE)
If the door is attached to the unit, remove it by un- 1.
screwing the top Allen head set screw at the top hinge.
Remove the door by angling the door off of the bottom
hinge pin.
Install the supplied lock body into the wood panel.
2.
The lock and key assembly is supplied with your unit.
Secure the lock body by using the supplied 15mm
lock retaining nut and screwing it on the lock body’s
threaded section. Make sure that the lock’s set slot is
vertical, then tighten the 15mm nut with a 15mm deep
well socket.
Peel back door gasket to provide access to the screw
3.
holes used to mount the wood frame and the hole for
the lock’s extension section at the top of the door.
Set the wood frame flush to the front of the door in the
4.
desired location. Clamp wood frame to the door if
necessary. Check to see that the back of the lock in the
wood frame lines up with the hole in the door.
Insert the wood screws through the back of the door
5.
into the pilot holes in the wood frame and tighten.
Assemble the door lock’s Phillips screw, lock extension
6.
and lock cam and mount them to the back of the lock
body. The cam is to be oriented vertically, then tighten
the Phillips screw to secure the lock assembly.
Reinstall the door gasket by pressing into door chan-
7.
nel. Make certain the corners are inserted fully. Insert
the key into the lock and make sure the lock operates
properly.
Install the door to the unit. Use the supplied plastic
8.
washers as shown in Figure 7.
Realigning the door may be necessary. Any final door
9.
adjustments can be made using a 1/8 inch Allen head
driver to adjust the door’s hinges (see Figure 8).
Attach the door light striker plate as shown using the
10.
5/16 inch Hex or Phillips head screws provided. Make
certain the light is able to turn on and off when the
door is opened and closed.
Attach the door to the unit by reversing steps number 1
11.
above.
Insert the key into the lock and verify that the lock cam
12.
works properly with the catch bracket on the cabinet
front.
Key
Wood
Panel
Door
Lock
Extension
Lock Body
Lock Retainer Nut
4
Figure 6: Lock Installation Detail
Lock Cam
Phillips
Screw
Door
Gasket
NOTE: Two (2) brass lock extensions are
supplied with the Marvel Door Lock. The
longer one is for 3/4 inch thick panels,
and the shorter one is for 5/8 inch thick
panels.