Musical Fidelity A3.5 - Manual (Page 13)

Issue 5: 4 May 2005 A3.5 CD Instructions for use Page 13 of 17
SPECIAL FEATURES
That track number will now appear in the
display :
Press PROGRAM again on the remote control
- the next program step is selected, (prog 2)
and the track number reverts to zero ready for a
new entry :
SCAN INTRODUCTION
The scan-introduction function allows play
back of just the start of each track on the disc,
for instance to locate a preferred track by ear.
Press INTRO on the remote control, and if the
player has stopped, the display will show :
The first ten seconds (approximately) of each
track on the CD can then be played in sequence
by pressing either PLAY/PAUSE on the front
panel, or PLAY on the remote control.
Press INTRO again to cancel introduction
search mode. If INTRO mode is cancelled
while the A3.5 CD is still playing, the
remainder of the entire disc will be played.
PROGRAMMED PLAY
The built-in program memory allows you to
store up to 25 track numbers and then play
them back in the held order. Each track is
stored as a “step” in the program.
With the CD loaded and the player stopped,
first press PROGRAM on the remote control.
The following is then displayed :
On the remote control, press the numeric button
of the track number corresponding to the first
track you wish to store (number 3 for example).
(continued . . .)
Continue entering track numbers in the same
way up to a maximum of 25. If more than 25
tracks are attempted accidentally, the memory
will not accept any extra ones, and the display
reverts to “prog 1”.
Remember that when entering a single-digit
track number, there is a delay of about two
seconds before the display accepts the entry -
this is to allow time for a second button to be
pressed when a double-digit number is
required.
If an incorrect entry is made, say track 9 when
there are only 7 tracks available on the disc,
“INVALID TRACK” is briefly shown, and
the entry automatically cancelled.
If at any time you wish to add a track to the list,
press the CLEAR button to obtain the next step
number. Alternatively, to delete a previous
entry, press CLEAR a second time to remove
the last entry. Repeated pressing of CLEAR
will then erase each step in reverse order. So to
delete an entire program sequence from the
memory, press CLEAR repeatedly until
“prog 1” is shown in the display.
When the last track number has been selected,
press PROGRAM a final time, then the PLAY
button to start the program sequence.
(continued . . .)