Musical Fidelity A3.5 - Manual (Page 14)

Issue 5: 4 May 2005 A3.5 CD Instructions for use Page 14 of 17
SPECIAL FEATURES
If you wish to check the selection before
playing back your program, the CHECK
button can be pressed to step through each
program entry in turn.
If during this check sequence the PLAY button
is pressed, the remaining part of your
programmed selection will play to the end of
the sequence.
Otherwise, to play all the programmed tracks
from the beginning of the sequence, press
PLAY/PAUSE, or PLAY on the remote
control.
The >>| button may be pressed to jump to the
next track in the programmed sequence, or
|<< button to obtain the previous track in the
sequence.
When all programmed tracks have been played,
the CD player stops. The same track selection
can then be played again by pressing the
PLAY/PAUSE button on the front panel, or
PLAY on the remote control.
To repeat a programmed sequence continually,
press REPEAT whilst playing the program.
To cancel this mode, press PROGRAM.
Note:
The program contents will be cleared if you
switch off the power, or open the disc drawer
and load another disc. If, however, the same
disc is loaded again with the power still
switched on, the program sequence is retained
in the memory. DISPLAY
A3.5 CD display brightness can be controlled
in three levels by pressing the DISPLAY
button on the remote control.
The original setting is maximum brightness,
but by pressing the DISPLAY button once,
brightness is reduced, and a further press turns
the display off.
However, when the display is off, pressing any
button returns the brightness to normal
(maximum).