Interference, Turn off remote start, Shut down input for remote starter – Magnadyne M12A User Manual

Page 14: Turbo timer mode

Advertising
background image

Interference

4/5/6

5

4

C

SET

Bi

6

Note: The transmission range may

become shorter if the system is

interfered by a stronger radio

frequency from sources of high

voltage electric power or obstacles

like tall buildings. The transmitter

uses low output powered

frequency.

14

Turbo Timer Mode

(Also See Installation Manual)

Turbo Timer Mode keeps the engine running after arriving at you destination for a programmable

time period of 1, 3 or 5 minutes. This allows the system’s time to conveniently cool down the turbo

charger after you have left the vehicle.

To Activate:

1. While the engine is running, set the emergency brake and place the transmission to "Park".

2. Before turning off the engine, press and release and buttons at the same time. The light

will flash to indicate the remote start has entered Turbo Timer Mode.

3. Remove the ignition key from the key cylinder. The engine will keep running.

4. Exit and secure the vehicle. The engine continues running until the preprogrammed time has

elapsed.

Turn Off Remote Start

When the engine is running by remote start and you wish to stop the engine from remote start:

1. Press the button twice on the remote transmitter.

2. Move the optional remote start toggle switch to the “OFF” position (if installed).

3. Press the vehicle’s brake pedal, the engine will stop running and the parking lights turn off to

indicate the engine has stopped.

Shut Down Input for Remote Starter

If any of the following conditions exist while the system is operating, the engine will not start or will

shut down immediately:

1. The hood is opened.

2. The brake pedal is pressed.

3. The hand brake is released (for Standard Transmission vehicles only).

4. Engine is over-reeved (Tachometer Checking Type only).

5. The preprogrammed run time (5/10/20/30 minutes) has elapsed.

6. Press the button twice on the remote transmitter under Remote Start Mode.

7. Move the optional remote start enable toggle switch to “OFF” position (if installed).

8. The vehicle refused to start running after 3 unsuccessful attempts.

M12A-UM 5/23/06 12:43 PM Page 14

Advertising