Miller Camera Support 1014 - Manual (Page 6)

OPERATING INSTRUCTIONS
6
The Operating Instructions for Arrow series fluid heads are
described in six (6) steps. Please read and understand these
instructions before using this equipment. Do not omit any
step.
1.1 Unscrew the CLAMP NUT from its threaded stud.
1.2 Place the head in your 100mm tripod bowl and re-fit the
CLAMP NUT. Do not tighten CLAMP NUT.
1.3 Level the fluid head by centering the bubble in the
BUBBLE LEVEL. Then tighten the CLAMP NUT.
1.4 In low light conditions the BUBBLE LEVEL can be
illuminated by pressing the ILLUMINATION BUTTON.
1.5 Note: If adjusting the level with your camera mounted,
first ensure the camera is securely held before loosening
CLAMP NUT.
1 INSTALL AND LEVEL THE HEAD
ILLUMINATION BUTTON
BUBBLE LEVEL
TRIPOD BOWL
THREADED STUD
CLAMP NUT
FIG 3