Melissa exido 258-015 - Manual (Page 19)

19
Hang appliance on wall bracket. Check it is level. Adjust the
two rubber spaces at back of appliance if required. Take ap-
pliance down again.
Use one M4X20 screw to fit the appliance on the screw hole
(
* ) on the bracket.
Make sure the appliance is fixed and can not be moved.
Connect flexible hose to extractor nozzle on top of appliance.
Note that hose ends have different diameters (printed on
outside of hose) Insert the 153 mm diameter end on nozzle. Fit
chimney on hood using the 8 small screws supplied on back
of appliance. Loosen protective film on back of chimney for
peeling off later.
Mount appliance on wall bracket. Extend upper part of chim-
ney from lower up to ceiling. Mark position of upper bracket
on wall. Push upper part of chimney down again. Screw
bracket firmly to wall where marked.
Fit flexible hose on extractor damper in wall or loft. Use an
adapter if necessary. Fit 150 mm diameter end to damper.
Electrical connection
Connect to mains socket (which must be accessible and com-
ply with relevant regulations).
If connected directly to mains, a multipole circuit-breaker
must be fitted between appliance and mains with a minimum
distance between contacts of 3 mm and with appropriate
ratings for the mains supply and in accordance with relevant
regulations.