Melissa exido 258-015 - Manual (Page 20)

20
If active carbon filters are to be used instead of extraction
damper, they must be fitted on sides of motor:
• Remove filter panel (6) by pressing lock button (5), on
lower panel and pull out. Fit carbon filters to motor sides.
• Do not fit flexible hose if carbon filters are to be used.
Extend upper part of chimney from lower, secure to bracket
using 2 small screws. Peel protective film off.
Fit the four plastic washers to underside of holes in glass plate
(3), carefully place glass plate on appliance with washers
facing downwards. Align holes with those on top of appliance.
Screw plate to appliance with the 4 screws with rubber wa-
shers. Do not over-tighten screws!
Tip! If rubber washers are displaced, push back into place
with screwdriver before inserting screw.
OPERATION
• Press light switch (a) to switch lights (7) on underside of
hood on or off.
• Press one of the three suction power controls (b, c or d) to
activate hood at desired power setting:
o b = high power
o c = medium power
o d = low power
• Press off switch (e) to turn appliance off.
• If two power controls are accidentally activated simulta-
neously, the appliance will start at the higher setting.
REPLACING LIGHT BULB
• Switch appliance off.
• Remove filter panel by pressing lock button, lower panel
and pull out.
• Carefully insert a screwdriver under light housing edge
and lever free from hood underside. Detach light from
hood by pressing stud on one side of the white clip and
detaching clips.
• Slacken the 4 screws in light back plate, detach plate and
detach light. Do not drop light lens!
• Remove halogen bulb.
o Warning! Bulbs in lights can become very hot when in
use.
o Never touch bulbs with fingers. Always use a cloth or
similar to prevent sweat or dirt from fingers reducing bulb
life.
• Insert new halogen bulb. Assemble and fit light housing in
reverse order.