Siemens Xelibri 5 - Manual (Page 4)

Getting Started
3
right page (3) of PACO e2, A31008-H9250-A45-2-7619 (25.09.2003, 19:47)
© Siemens AG 2003, P:\PN\ISDN\XELIBRI Vers. 2\UGS\PACO\e2\paco_getting_started.fm
VAR Language: ENG; VAR issue date: 18-September-2003
Getting
Started Fitting battery
Unclip your Xelibri’s case (1) and, pressing the arrow on
the battery cover, slide towards bottom of phone (2).
Engage the battery tabs in the slots (3), then swing into
place (4). Refit the battery cover and re-clip.
To remove battery, lift tab at the bottom.
Fitting SIM card
Your service provider supplies
your SIM card. If it’s credit
card size, snap out the smaller
portion and tidy any rough
edges.
Flip open the cover (5) at the
side of your Xelibri to reveal
SIM slot and charger socket.
Insert the SIM in the top slot, positioning the cut-off cor-
ner as shown. Press until it clicks into place.
The SIM is spring-loaded – to remove, press it in.
Charging
Insert the supplied
charger into an easily
accessible mains socket
of the correct rating
and, opening the SIM
cover, plug into the bot-
tom socket with the pins
face up.
While it charges, the battery indicator will animate – if it
doesn’t, then see What if...? on p 21. Allow 2-3 hours
for a full charge.
Be sure to unplug the charger from the mains when
you’re finished.
4
2
1 3
5
paco.book Seite 3 Donnerstag, 25. September 2003 7:48 19