Miller Electric S-22P12 - Manual (Page 18)

OM-181 931 Page 14
3-8. Installing And Threading Welding Wire
ST-156 377-B / Ref. ST-159 048-A / S-0627-A
Install wire spool.
Adjust tension screw so wire is taut
when wire feed stops.
Lay gun cable out straight.
Open pressure assembly, hold wire
tightly, and cut off end. Push wire
through guides into gun.
Close and tighten pressure assem-
bly. Press JOG button until wire
comes out gun.
To adjust drive roll pressure, press
gun trigger to feed wire against
wood surface. Tighten knob so wire
does not slip.
Cut off wire. Close door.
Tools Needed:
9/16 in
WOOD
Tighten