Musical Fidelity A1 - Manual (Page 15)

A1 PRO CD
MANUAL REVISION
Issue 4: 6 th May 2008 Page 15 of 16
DAC: Output impedance 50 Ohms
DAC circuit 24 bit Delta-Sigma (Bit stream) dual differential 8X over sampling
Total correlated jitter < 135 pS
< 0.1dB down to -96dB
Linearity
2.18VRMS at 1 kHz nominal Output digital 0dB
level
10Hz to 20 kHz -0.2dB max Frequency response
Channel separation > 105dB 20Hz to 20 kHz
Signal / noise ratio > 117dB “A” weighted
Total harmonic
distortion
< 0.003% 10Hz to 20 kHz
Connections: Line level outputs: 1 pair RCA outputs
Digital outputs 1 S/PDIF (RCA connector)
1 optical (TOSLINK)
Power
requirement:
100 / 115 / 230Volts
AC 50 / 60Hz
(factory pre-set), 15 Watts maximum
Standard
accessories:
A1 Power supply lead 1.0 m 39 ¼ inches 1 off
Mains lead 10 Amp IEC type 1 off
Remote control A1, universal 1 off
Magnetic puck Disk clamping puck 1 off
Batteries Size LR03 or AAA
manganese alkaline type 2 off
Dimensions:
Main unit
440 mm 17⅓ inches wide
78 mm 3 inches high inc. feet, lid closed
(250mm [9 ¾ inches] minimum height clearance required to fully open lid)
280mm 11 inches deep inc. terminals
Weight: 10.1 kg, 22¼ lbs Unboxed
12.6 kg 27 ¾ lbs Boxed unit including all accessories
Musical Fidelity reserves the right to make improvements which may result in specification or feature
changes without notice.