MITSUBISHI ELECTRIC SE1U - Manual (Page 16)

31
Operations
30
■ The display setting menu
Use this menu to set screen display-related items.
(Full): Display with LCD panel’s resolution
(Thru): Display with sampling resolution (for computer input)
(Wide): Wide-screen display (for Video, S-video, and Y/P
B /P R )
Select one of the languages below to use for displaying menus and messages
[ : Enter setting mode] [ :Selection] [Apply: ]
English/Français/Deutsch/Italiano/Español/
Português/ / / /
Screen to display when there is no input signal (Logo) (Blue) (None)
Display icons as function guides On Off
Display start-up screen when power turned on On Off
Description Item
Screen size
Language
Background
Icon
Start-up screen
Notes
• If “Thru” is selected for screen size, portions exceeding the pixel count of the LCD panel
p.37 will not appear on the screen. Note that for RGB signals with clock speeds
SXGA3_60 p.38 or lower, all input pixel signals are sampled. However, if the clock speed
is higher than this, the RGB pixel signal is reduced before sampling.
• Displaying the images with the aspect ratio different from the original with the purpose of
other than the personal and private viewing, using the screen size menu may violate the
copyright protected by the law.
■ Reset menu (Special menu)
When other menus are not displayed and the button is held down, the menu appears.
• Select Reset All and press the button to return all menu items to the factory settings.
Reset all menu items to their factory settings
[ : Enter execution mode] [Yes No] [Apply: ]
Description Item
Reset all
Using the menu (Continued)
■ The image adjustment menu
Use this menu to adjust image-related items.
Items that can be adjusted are marked with “Yes”, and those that cannot are marked with “No”.
Item Description Computer Y/P B /P R Video S-video
Contrast Lower Higher Yes Yes Yes Yes
Brightness Darker Brighter Yes Yes Yes Yes
Color Lighter Deeper No Yes Yes Yes
Tint [Note 1] Reddish Greenish No No Yes Yes
Sharpness Softer Sharper No Yes Yes Yes
R-level Less red More red Yes Yes Yes Yes
G-level Less green More green Yes Yes Yes Yes
B-level Less blue More blue Yes Yes Yes Yes
Up/down shift [Note 2] Shift down Shift up No Yes Yes Yes
Notes
1: Tint can only be adjusted when Video mode
p.24 is set to NTSC or NTSC4.43.
2: Up/down shift can only be adjusted when Screen size p.31 is set Wide.
■ The default setting menu
This menu shows placement status and other settings.
Sets projection mode in accordance with Placement Style
Sets the period of time to wait until turning off the power after signal input stops:
Off (not turned off) 1 min 2 min ... 60 min
Sets whether to turn on the power when the ON/STANDBY button is pressed
(Manual), or when the AC power cord is plugged in (Auto). Manual Auto
Sets the lamp power Standard Low
Description Item
Projection
mode
No signal
power off
Power on
Lamp power [Note 1]
(Back hung
from ceiling) (Placed
on floor) (Rear) (Hung from
ceiling)
p.18
Note
1: When Lamp power is set to low, the screen becomes a little darker, but the cooling fan noise gets
quieter.
Notes
• Note that if Power on is set to Auto, then if the AC power cord is plugged in when power
is restored after a power outage, the projector power will come on.
• Even if Power on is set to Auto, press the ON/STANDBY button to turn off the power.
Unplugging the AC power cord to cut off the power will shorten the life of the lamp.