Personalizing your endpoint, Adjusting the viewing angle, Personalizing – Mitel 5212 User Manual
Page 27: Yo u, Person, Alizi, Ur en, Adjusting the viewing angle” on
Mitel
®
Model 5212/5224 IP Endpoint User Guide for Inter-Tel
®
5000 Systems
9
Personalizing
Yo
u
r E
n
d
p
o
n
t
Personalizing Your Endpoint
This chapter describes features you can use to personalize your endpoint.
Adjusting the Viewing Angle
You can tilt the endpoint stand for a better view of the buttons and display.
To adjust the viewing angle:
1. Turn the endpoint so it faces away from you.
2. Hold the base firmly, and then press the tabs on the sides of the stand to release
and detach the base unit.
3. Hinge the hooks on the base unit into the notches on the back of the endpoint, and
then snap into place as follows:
•
For a high-angle mount, hinge the two lower hooks into the bottom set of
notches, and then snap the two upper hooks into the middle set of notches.
•
For a low-angle mount, hinge the two lower hooks into the middle set of
notches, and then snap the two upper hooks into the top set of notches.
Press tabs on both sides
to release and detach unit.