Memorex MMG-CR3810 - Manual (Page 10)

7. Insert screws from the
INSIDE of the cabinet. The
washers must be used on
metal cabinets and wood
cabinets if the drilled holes
were not countersunk.
Position the washers, flat-
side down, and insert the
screws into the holes.
8. If your cabinet does not
have an overhang, skip
this step.
If your cabinet has an
overhang,
hold the
screwheads down while you
push the selected spacers
upward onto the screws
under the cabinet. Make
sure to push up spacers
until they are firmly against
the cabinet bottom and/or
fully nested (if more than
one are used).
9. Align the unit under the
screws. Hold the unit so its
mounting screw holes (on
the top of the unit) are
against the mounting
screws (see Figure 6) , then
partially tighten the screws.
NOTE: Do not fully tighten until
all 4 screws have been started.
The top edge of the unit should
clear the overhang.
10. Extend the cord towards the AC outlet (see page 5) and secure it by using
cord hooks (not supplied) to keep the cord out of the way. For more attractive
appearance, place the cord hooks at the back edge of the cabinet, directly
over the AC outlet. It is recommended that the line cord be fully extended for
best FM reception.
11. Connect the Remote Stand to the bottom of the unit by sliding it towards the
rear of the unit.
9
MOUNTING (CONTINUED)
Figure 5
Mounting Screws
Washers
or or
or or
or or
Spacers Spacers
or or
Figure 6
SELECT SCREWS WHICH MEET MINIMUM, BUT DO NOT
EXCEED MAXIMUM LENGTH
MMG-CR3810.OM.QXD 7/15/02 7:09 AM Page 9