Memorex MMG-CR3810 - Manual (Page 11)

10
OPERATION
TO SET OR RESET THE ACTUAL TIME
Press and hold the TIMER button ❶;
the display will show “00:00” and the
hour digits will blink. Use the
SKIP/TUNING
/ buttons ❷ to
select the amount of hours in the
countdown.
2
2
1
1
Press the TIMER button ❶ again and
the minute digits will blink. Use the
SKIP/TUNING
/ buttons ❷ to
select the amount of minutes in the
countdown. Press the TIMER button ❶
to return to the actual time.
2
2
1
2
When the unit is off, press the
MEMORY/CLOCK SET button.
1
Press the SKIP/TUNING /
buttons ❶ to set the hour, then press the
MEMORY/CLOCK SET button ❷. Press
the SKIP/TUNING
/ buttons ❶
to set the minutes, then press the
MEMORY/CLOCK SET button ❷ again.
1
1
2
2
TO SET THE COUNTDOWN TIMER
IMPORTANT NOTE ON THE COUNTDOWN TIMER:
The above procedure will set the amount of time that the timer will countdown
EVERY TIME THE TIMER IS PRESSED. To activate the countdown timer, or to
change the countdown timer, see the following page.
MMG-CR3810.OM.QXD 7/15/02 7:09 AM Page 10