Invacare 9805P - Manual (Page 18)

SECTION 4—ASSEMBLY
Portable Patient Lift and Sling 18 Part No 1024492
Base Shifter Handle Assembly
NOTE: For this procedure, refer to
FIGURE 4.3.
1. Insert the base shifter handle into the
cam lock assembly at the back of the
base.
2. Align the holes of the shifter handle
and cam lock assembly.
3. Tighten the thumbscrew to secure the
shifter handle in place.
NOTE: This should prevent the base shifter
handle from being removed.
FIGURE 4.3 Base Shifter Handle Assembly
Swivel Bar Attachment with Mounting Bracket
NOTE: For this procedure, refer to FIGURE 4.4.
1. Push the pin and washers up through the swivel bar pad.
2. Line-up hole in pin with mounting bracket holes and secure with shoulder screw and
nut provided.
NOTE: The swivel bar has hooks on both ends to accept the hardware used to attach the sling that
supports the patient during lift. The swivel bar pad should remain in place during normal use.
FIGURE 4.4 Swivel Bar Attachment with Mounting Bracket
Thumbscrew
Base Shifter Handle
Cam Lock
Assembly
Swivel Bar Pad
Pin
Nut
Shoulder
Screw
NOTE: Make sure Pin and Washers are completely
pushed up through the Swivel Bar Pad.