Invacare 9805P - Manual (Page 20)

SECTION 5—ONE-PIECE CONTOUR SLINGS
Portable Patient Lift and Sling 20 Part No 1024492
Positioning the Contour Sling
NOTE: For this procedure, refer to FIGURE 5.1.
1. Position the patient in the center of the bed and laying flat on his/her back.
2. Fold the sling in half (length-wise) and place the fabric sections of the sling beside the
patient.
NOTE: The sling french seams (uneven surface) will be against the bed surface and facing the
assistant when folded. The opposite side of the fabric is smooth. After the sling is positioned for
lifting purposes, the smooth side will be next to the patient.
NOTE: The top edge of the sling fabric (nearest to the patient’s head) should be slightly above the
armpit level of the patient.
NOTE: The bottom edge of the sling fabric should then be a few inches above the back of the
patient’s knee.
3. With both assistants holding the patient, push the folded sling under the patient
without rolling him/her over.
FIGURE 5.1 Positioning the Contour Sling
Center of Bed
Top Edge
of Sling
French Seams
(Facing the
assistant and Bed
Surface)
Bottom Edge
of Sling
DETAIL “B” - PREPPING PATIENT
DETAIL “D” - ROLLING PATIENT BACK DETAIL “C” - ROLLING
PATIENT TO SIDE
DETAIL “A” - POSITIONING