Intel IXM5414E - Manual (Page 200)

190 Intel® Blade Server Ethernet Switch Module IXM5414E
Port GMRP Mode
Indicates the GMRP administrative mode for the port. It may be enabled or
disabled. If this parameter is disabled, Join Time, Leave Time and LeaveAll Time
have no effect. The factory default is disabled.
Port GVRP Mode
Indicates the GVRP administrative mode for the port. It may be enabled or disabled.
If this parameter is disabled, Join Time, Leave Time and LeaveAll Time have no
effect. The factory default is disabled.
IGMP snooping commands
config igmpsnooping adminmode
Use this command to enable or disable IGMP Snooping on the switch module.
Default disable
Format config igmpsnooping adminmode <enable/disable>
config igmpsnooping groupmembershipinterval
Use this command to configure the IGMP Group Membership Interval time on the IXM5414E
switch module. The group membership interval time is the amount of time in seconds that a switch
will wait for a report from a particular group on a particular interface before deleting the interface
from the entry. This value must be greater than the IGMP maximum response time value. The range
is 2 to 3600 seconds.
Default 260 seconds
Format config igmpsnooping groupmembershipinterval <2-3600>
config igmpsnooping interfacemode
Use this command to enable or disable IGMP Snooping on a selected interface. The
<port/listofports/all> parameter identifies the interface(s) on which to enable or disable IGMP
Snooping. If an interface which has IGMP Snooping enabled is enabled for routing or becomes a
member of a LAG, IGMP Snooping functionality will be disabled on that interface. IGMP Snooping
functionality will subsequently be re-enabled if routing is disabled, or the interface is deleted from
the LAG.
Default disable
Format config igmpsnooping interfacemode <port/listofports/all> <enable/disable>
config igmpsnooping maxresponse
Use this command to configure the IGMP Maximum Response time on the IXM5414E switch
module. The maximum response time is the amount of time in seconds that a switch will wait after
sending a query on an interface because it did not receive a report for a particular group in that
interface. This value must be less than the IGMP query interval time value. The range is 1 to 3599
seconds.
Default 10 seconds
Format config igmpsnooping maxresponse <1-3599>