IDEAL INDUSTRIES 45-935 - Manual (Page 10)

10
STP Operation continued
Set Mode
1 — STRIP LENGTH INCREMENT
This allows programming the strip length in increments by using the arrow keys to increase or decrease the length appearing on the display.
ENGLISH LENGTH MODE - (0.01 in. to 0.99 in.) The tenths position begins blinking. After the tenths digit is entered, the hundredth position blinks.
After the hundredth digit is entered the unit will automatically return to ready mode.
METRIC LENGTH MODE - (1 mm to 99 mm) Enter the increment length, 1mm to 9 mm, and press ENTER. Increment lengths of 10 mm to 99 mm
are automatically entered after being typed in.
2 — SECURITY CODE
Enter the new 3-digit code. CLEAR can be pressed any time during this process and the current 3-digit code is restored.
3 — SELECT UNITS (IN/MM)
This allows the selection of English or metric units. Press [1] for English or [2] for metric.
4 — KEYBOARD LOCKOUT
This allows locking out everything on the keyboard except for calling up batches and adjusting the strip length. Press [1] for lock on or [2] for lock off.
5 — COUNTS
There is an 8-digit counter that starts at 0 when the machine is built and counts every cycle. This counter is nonresettable. There is a 6-digit
counter that counts every cycle and is resettable.
[1] (Warning On) activates the “SERVICE MACHINE” warning
that appears at the end of a cycle if the resettable count is equal to or
above the limit that has been set.
[2] (Warning Off) disables the “SERVICE MACHINE” warning.
[3] (Set Service Limit) allows setting the limit of cycles to when the warning should go off (from 0 to 999999). This also is a reminder to
reset the count.
[4] (Clear Service Count) resets the count.
When the service count is reached a warning is flashed at the end of every cycle if the “warning on” is set.
The counts can be displayed during the ready mode by pressing and holding down COUNT. When the COUNT key is released, the display returns to
the ready to strip mode.
ENTER NEW CODE
NEW CODE =
SELECT
1—ENGLISH 2—METRIC
1—INCR 2—CODE 3—UNIT
4—LOCK OUT 5—COUNT
SET STRIPLENGTH
INCREMENT 0.00 IN
SET STRIPLENGTH
I NCREMENT 0 MM
LOCK OUT
1—LOCK ON 2—LOCK OFF
1—WARN ON 2—WARN OFF
3—SET LIM 4—CLR CNT