IBM PowerLook 2100XL - Manual (Page 9)

To reset the SCSI ID, do the following:
1. Make sure the scanner power is off.
2. Use a screwdriver to rotate the SCSI ID switch on the SCSI ID switch until an unused number
appears in the switch’s notch.
Note: Do not use SCSI ID setting from 7 through 9 on your scanner. They are for factory use
only.
Care and Maintenance Tips
Regularly clean the object glass of the scanner and the transparency adapter to prevent dirt or
smudge build-up that may reduce the quality of your scanned images. Before you clean the object
glass, make sure the scanner power is off and the power cord is unplugged.
Clean the object glass of the scanner and the transparency adapter with a soft damp cloth and a
mild detergent or alcohol.
Note: Avoid spraying cleaning fluid directly on the object glass. This may cause the liquid to
penetrate the seams around the glass and contaminate the mirrors and lenses inside the
scanner. Spray the liquid on the cleaning cloth then wipe the glass clean.
Be sure that nothing covers the calibration area. It is important to keep the calibration area clean
since dust or smudge marks on the glass will reduce the quality of scanned transparencies. Make
sure the transparency fits in the scanning area.
Do not leave transparencies on the object glass of the scanner for excessive periods of time. The
warmth of the scanner and transparency adapter lamps may cause them to deteriorate. Please, use
the Frame holder to secure the transparencies for scanning.
9