IFoundry Systems IFSYS-5651 MSP430 - Manual (Page 19)

Page 19 of 50 Copyright © 2008 iFoundry Systems
IFSYS-5651 MSP430 Bluetooth Evaluation Kit User Guide
6.2 Configuration for MSP430 software development
Connect up the IFSYS-5651 Development Board as follows:
• Connect the USB cable provided with your evaluation kit between the miniUSB port of
the IFSYS-5651 and a USB port on the PC. This is primarily to supply power to the
IFSYS-5651 board. It is recommended that the developer should have installed the
USB -to-Serial driver for this board previously. Instructions for this can be found in
Section 11 - INSTALLING THE USB-TO-SERIAL DRIVER.
• Ensure that the IFSYS-5651 board is not configured in firmware download mode
• Ensure that the IFSYS-5651 peripherals are configured appropriately.
6.3 Board configuration/Jumper settings
Connect up the IFSYS-5651 Development Board as follows:
• Prior to connecting up the board, ensure that the following jumper settings are in
place:
•
MODE jumper – this should be set to NORM position (installed on pins 1-2)
•
5043CONN jumper – should be set to INT (installed on pins 1-2). This makes
available Bluetooth connectivity to your application.
•
LEDSEL – should be set to MSP430 (installed on pins 1-2), to enable MSP430 to
control LEDs.
• Attach the JTAG debugger to the JTAG port on the IFSYS-5651 board, ensuring that
the JTAG debugger is not powered on (ie plug into the PC’s USB port),
• Next connect the USB cable to a PC. Power up the PC, if not already on.
• Now connect the JTAG debugger to the PC’s USB port, and start up your
development environment.