Specifications, Legal notices, Fcc part 15 – Insignia NS-R5100 User Manual

Page 23: Fcc warning, Canada ices-003 statement, Specifications legal notices

Advertising
background image

21

Insignia NS-R5100 AV Digital Home Theater Receiver

www.insignia-products.com

Specifications

Legal notices

FCC Part 15

This device complies with Part 15 of the FCC Rules.
Operation of this product is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply within
the limits for a class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and
receiver.

Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.

Consult the dealer or an experienced technician for
help.

FCC warning

Changes or modifications not expressly approved by the
party responsible for compliance with the FCC Rules could
void the user’s authority to operate this equipment.

Canada ICES-003 statement

This Class B digital apparatus complies with Canadian
ICES-003.

Poor FM
reception

1

No antenna is
connected.

2

The antenna is not
positioned for the
best reception.

1

Connect an
antenna.

2

Change the position
of the antenna.

Continuous
hissing
noise during
FM
reception,
especially
when a
stereo
broadcast is
received.

Weak signals.

1

Change the position
of the antenna.

2

Install an outdoor
FM antenna.

Continuous
or
intermittent
hissing
noise during
AM
reception,
especially at
night.

Noise is caused by
motors, fluorescent
lamps, or lightning.

1

Keep the receiver
away from noise
sources.

2

Install an outdoor
AM antenna.

Remote
control unit
does not
operate.

1

Batteries are not
loaded or are
exhausted.

2

The remote sensor
is obstructed.

1

Replace the
batteries.

2

Remove the
obstacle.

Note

Design and specifications are subject to
change without notice.

Weight and dimensions shown are
approximate.

Specifications and external appearance may
be changed for the sake of improvement.

Amplifier Power output, stereo mode, 6

Ω, THD 0.7%,

40 Hz~20 kHz: 2×100 W

Total harmonic distortion, 6

Ω, 100 W, 1 kHz: 0.09%

Intermodulation distortion, 60 Hz, 7 kHz= 4:1 SMPTE,
6

Ω, 100 W: 0.1 %

Input sensitivity, 47 k

Ω, Line (CD, TAPE, VIDEO):

280 mV

Signal to noise ratio, IHF “A” weighted, Line (CD, TAPE,
VIDEO): 92 dB

Frequency response Line (CD, TAPE, VIDEO),
20 Hz~50 kHz: +0 dB, -3 dB

Output level

TAPE REC, 2.2 k

Ω: 280 mV

PRE OUT (Subwoofer), 1 k

Ω:1.0 V

Bass/Treble control, 100 Hz/10 kHz: ±10 dB

Surround mode, only channel driven

Front power output, 6

Ω, 1 kHz, THD 0.7%: 125 W /

125 W
Center power output, 6

Ω, 1 kHz, THD 0.7%: 125 W

Surround power output, 6

Ω, 1 kHz, THD 0.7%:

125 W / 125 W

Digital
Audio

Sampling frequency: 32, 44.1, 48, 96 kHz

Digital input level

Coaxial, 75

Ω: 0.5 Vp-p

Optical, 660 nm: -15~-21 dBm

Category

Problem

Possible Solution

Video

Video format: NTSC

Input sensitivity (=Output level), 75

Video (Composite (normal)): 1 Vp-p
S-Video (luminance signal): 1 Vp-p

(chrominance signal): 0.286 Vp-p

Component video (R-Y signal): 0.5 Vp-p

(B-Y signal): 0.5 Vp-p
(Y signal): 1.0 Vp-p

FM Tuner Tuning frequency range: 87.5~108 MHz

Usable sensitivity, THD 3%, S/N 30 dB: 12.8 dBf

46 dB quieting sensitivity, mono/stereo: 20.2 / 45.3 dBf

Signal to noise ratio, 65 dBf, mono/stereo: 55 / 50 dB

Total harmonic distortion, 65 dBf,1 kHz, mono/stereo:
0.5 / 1.0%

Frequency response, 30 Hz~12 kHz: ±3.0 dB

Stereo separation, 1 kHz: 30 dB

Capture ratio: 4 dB

IF rejection ratio: 80 dB

AM
Tuner

Tuning frequency range: 520~1710 kHz

Usable sensitivity: 500 µV/m

Signal to noise ratio: 40 dB

Selectivity: 25 dB

General

Power supply: 120 V ~ 60 Hz

Power consumption: 3.8 A

Dimensions (W×H×D, including protruding parts):
17-3/8Ч5-1/2Ч14-3/4 inches (440Ч141Ч376 mm)

Weight (Net): 20.5 lbs (9.3 kg)

Advertising