Iiyama PROLITE B2403WS - Manual (Page 18)

ENGLISH
14 OPERATING THE MONITOR
Adjustment Item Problem / Option Button to Press
Miscellaneous
Sharpness
1 2 3 4 5
You can change the picture quality from 1 to 5 (sharp to soft).
Press the Button to change the picture quality in numerical
order. Press the Button to change the picture quality in reverse
numerical order.
DDC/CI
DDC/CI is turned ON. On
Off DDC/CI is turned OFF.
See your graphic card user guide for more information
about changing the resolution and refresh.
NOTE
Displays information regarding the current input signal coming
from the graphic card in your computer.
Display Information
DDC/CI On and Off are switched as follows by pressing the Button successively.
On Off
NOTE
M i s c e l l a n e o u s
D i s p l ay I n fo r m a t i o n
1 9 2 0 x 1 2 0 0 @ 6 0 H z
DCR
Increased Contrast Ratio On
Off Typical Contrast Ratio
OD * 1
You can set the OverDrive level between 0 and 5. It will improve
the gray level response time of the LCD panel. A higher level
results in a faster response time.
Display Mode * 2
Expansion display Full
1 : 1 Displayed at the same magnification
Aspect Expansion display of Aspect
* 1 OD cannot enable at the same time when Display Mode is set to 1 : 1 or Aspect, and Vertical
Frequency is more than 60Hz. When OD is activated, some level of image retention will be caused.
For optimal viewing, the recommended level is 3 or lower.
* 2 Display Mode is locked to Full and you cannot select 1 : 1 or Aspect when receiving 1920 x 1080
signal.
0 1 2 3 4 5
PLB_E2403WS-e-M021B01.P65 2007/09/03, 9:54 18