IFB Appliances AW60-9021 - Manual (Page 3)

NAMES OF RESPECTIVE PARTS
1. Top lid 2. Washing tub 3. Gradienter 4. Operation panel 5. Filter 6.
Adjustable foot . 7. Pulsator 8. Top frame 9. Drain hose
3
The washing machine should be placed inside the room with a flat floor, which is
convenient for water supply and drain, has low moisture and no direct sunshine, and does
not freeze in winter.
Please adjust the washing machine even according to the instructions below to make the
washing machine run steadily in low noise.
1. Loosen the fixing pole on the adjusting foot, screw in or screw out the adjusting foot
to make the four foot placed even on the floor.
2. When the floor is slanting or uneven, it is not easy to make even only by the
adjusting foot. Then the rubber band can be added to the unflat place.
3. Use gradienter to check whether the washing machine is placed flat.
4. After the adjustment the fixing pole should be screwed back and tight.
Notices:
o If the washing machine is not placed flat (the inclination angle is over 2 ), it may
cause great vibration or automatic check and rectification or other abnormal circumstances
will often take place in the course of spinning.
Screw in
Screw out
Loose
Adjustable foot
Fixing pole
Tight
Base foam
Simple installation
Bubble
Gradienter mark
4
Base cover (1)
Self-tapping screw (1)
Water inlet hose assembly(2)
Accessories (Part of standard machine)
Drain hose (1) Universal connector(2)
Fixing ring(1) is used for the
fixation in time of the installation
of the drain hose