ID Tech 70 - Manual (Page 22)

ADD FIELD JJ<ENTER>
This command allows you to add a character string to the output
record. After entering the ADD FIELD command, enter sequentially the
characters you wish to include in the output record. Any character (or
characters) from the ASCII or Function Code tables can be used. An
output field is created containing the character string. This command is
optional.
Note: Enter Ctrl-N for <CR>.
SEND FIELD SEQUENCE
JK<ENTER>[FIELD ID CHARACTER]
<ENTER>[FIELD ID CHARACTER]
<ENTER>[FIELD ID CHARACTER]<ENTER>
This command specifies the order in which the defined output fields
created will be transmitted. Each output field is assigned an upper case
alpha character in the order it is created, so the first output field
created is assigned the identification character “A”, the second “B”,
etc.
TIME DELAY JM<ENTER>n<ENTER>n<ENTER>
In addition to specifying the output field order, you can also add time
delays between fields. By entering the TIME DELAY command fol-
lowed by two numeric digits (nn), you can add a time delay between
fields to accommodate the processing time required by the host. The
amount of time delay added is equal to the value of “nn” multiplied by
100 milliseconds, so a value of “04” would give a delay of 400 millisec-
onds.
3 8 3 9
Data Editing General Commands
The following commands are used to set the operating parameters for
data editing:
DATA EDITING ENABLED
JA<ENTER>1 or 2
Entering the DATA EDITING command followed by entering the
ENABLE or DISABLE character will enable or disable the entire data
editing feature. When disabled, the data edit formula will be inactive,
but will still be retained in the Omni’s memory. When enabled, the data
edit formula will be used to format the data record.
SEND/SUPPRESS UNMATCHED
JB<ENTER>0 or 1
Entering the UNMATCHED INPUT command followed by the SEND or
DO NOT SEND character will enable or disable the transmission of data
that does not match the restrictions of the data editing formula. When
SEND is selected, unmatched data will be transmitted along with any
preamble or postamble settings. When DO NOT SEND is selected, none
of the unmatched data will be transmitted.