Infrasonic BLOW5D - Manual (Page 11)

BLOW5/BLOW5D User’s Manual
11
4. CONNECTION
4.1. P
OWERING
U
P
IMPORTANT NOTE
ƒ All connections should be made, And faders, volumes, sensitivity and other controls are at minimum levels.
ƒ Before powering up the BLOW5 speakers, all other equipment should be turned on first.
ƒ Please make sure that the unit is plugged into the correct voltage.
ƒ The power switch is located on the rear panel.
ƒ Turn on the power to the BLOW5.
ƒ The unit is equipped with a protection circuit, an interval of a few seconds is required before the unit will
operate normally.
4.2. A
NALOG
A
UDIO
I
NPUT
ƒ Connect the male side of an XLR balanced cable to the XLR input or TRS balanced (or unbalanced) cable
to the TRS input of the rear panel.
ƒ Input Select Switch should be set to analog input.
ƒ Refer to the following diagram.
< Connecting of Analog XLR balanced cable >
< Connecting of TRS Analog balanced/unbalanced cable >
TRS balanced cable
TRS unbalanced cable
XLR balanced cable