Cornelius Flavor Fusion 22127 User Manual
Page 3
Icemaker & Adaptor Hold-Down Kit Installation Instructions
© 2008, IMI Cornelius Inc.
- 3 -
Publication Number: 629096853INS
Figure 4
5.
Repeat Steps 1 through 4 for the opposite side of the dispenser.
6.
Using the supplied silicone tube, seal icemaker all around to the adapter top, as shown in Figure 5.
Figure 5
7.
Locate the icemaker mounting plates at the rear of the icemaker and position as shown in Figure 6, if plates
are not already installed.
NOTE: Kit contains two plates, both mounting plates must be installed.
Figure 6
8.
Using the plate as a template, drill 9/64 in. (0.140 in.) holes into the icemaker base and the dispenser, as
shown in Figure 7.
Flange on bracket
MUST Go Over the
Top of the Adapter
Lid as Shown.
Run a Continuous
Bead of Caulking
Around the Adapter
Top