Invacare LYNX PANTHER LX-4 - Manual (Page 12)

12 12
This Procedure Includes the Following:
Replacing Hand Grips
Replacing LED Canopy
Replacing Throttle Lever
Removing/Installing Tiller Assembly
Removing/Installing Boot
PROCEDURE 4 TILLER
WARNING
After ANY adjustments, repair or service
and BEFORE use, make sure that ALL
attaching hardware is tightened securely
- otherwise, injury or damage may occur.
Turn Power OFF and remove key from
ignition. Disconnect battery harness
from motor lead.
REPLACING HAND GRIPS
(FIGURE 1)
1. Grasp the hand grip and twist it off of the handle bar.
2. Slide the NEW hand grip over the handle bar.
3. If necessary, repeat STEPS 1-2 for the other hand
grip.
3. Repeat this procedure for the other pointed locking
tab of the LED canopy.
4. Remove the EXISTING LED canopy and the
EXISTING rubber gasket.
5. Discard the EXISTING LED canopy and the
EXISTING rubber gasket.
NOTE: Before installing the NEW LED canopy, be
sure the NEW rubber gasket is between the NEW
LED canopy and the front cover.
6. Align the NEW LED canopy with the mounting
holes in the front cover and snap it into place.
7. Align the pointed locking tabs of the NEW LED
canopy with the mounting holes in the electronics
board, and snap the electronics board into place.
T
I
L
L
E
R
Hand Grip
Handle Bar
Hand Grip
FIGURE 1 - REPLACING HAND GRIPS
FIGURE 2 - REPLACING LED CANOPY
LED Canopy
Pointed
Locking
Tab Pointed
Locking
Tab
Electronics
Board
Front
Cover
Rubber
Gasket
REPLACING LED CANOPY
(FIGURE 2)
NOTE: This procedure applies to all models EXCEPT
the Panther MX - 4.
1. Grasp one (1) of the pointed locking tabs of the
LED canopy under the front cover and squeeze
the ends of it together.
2. While squeezing the ends, slowly pull the pointed
locking tab through the front cover and through
the electronics board.
REPLACING THROTTLE LEVER
(FIGURE 3)
1. Remove the four (4) self-tapping screws and hous-
ings securing the cable cover to the tiller assembly.
NOTE: Save the four (4) self tapping screws and hous-
ings for reuse when installing the NEW throttle lever.
2. Slowly remove the cable cover from the tiller as-
sembly and allow it to hang by the connecting wires.
3. Remove the two (2) socket screws securing the
throttle lever to the potentiometer assembly.
4. Remove the throttle lever from the potentiometer
assembly.