Icom IC-2800H - Manual (Page 58)

■ Programming a DTMF code
DTMF codes are used for autopatching, accessing repeaters,
controlling other equipment, etc. The transceiver has 14
DTMF memory channels (D0–D9, DA–DD) for storage of
often-used DTMF codes of up to 16 digits.
q Push [DTMF] for 2 sec. to select the DTMF memory
screen.
• Push [CHG/L] if [DTMF] is not displayed.
w Push [ Y ] or [ Z ] to select the desired DTMF memory.
• Left-hand tuning dial can also select the item.
e Push [EDIT] to enter programming mode.
• The first character of the DTMF code flashes.
r Rotate the right-hand tuning dial to select the desired char-
acter.
• “E” stands for “ M ” and “F” stands for “#.”
• “–” indicates ‘no code’ and can be used to clear a previously pro-
grammed code.
t Push [ ≈ ] to advance to the next character.
• Push [ Ω ] to select the previous character.
y Repeat r and t until the desired code is input.
u Push [ ï ] to program the DTMF code and exit program-
ming mode.
i If you want to set other channels, repeat w through u .
o Push [ ï ] to exit the DTMF memory screen.
54
13
DTMF MEMORY
DTMF
D0
D1
D2
D3
0123456
0123456789AB
Tx Time 100ms TIME
EDIT
DTMF
D0
D1
D2
D3
0123456
0123456789AB
Tx Time 100ms
п