Icom IC-2800H - Manual (Page 80)

■ Getting started
D This cloning software is designed to perform data setting
and cloning for the IC-2800H DUAL BAND FM transceiver.
D HELP WINDOW: Each item has a help window to describe
functions and operation.
■ System requirements
To use this program, the following hardware and software are
required:
• IBM PC/AT compatible computer
• An RS-232C serial port
• Microsoft
® Windows ® 95 or Microsoft ® Windows ® 98
• Intel i486DX4 processor or faster
• At least 16 MB RAM
• At least 640
×
480 pixel display
• OPC-478 CLONING CABLE
■ Software installation
NOTE: Before using the program, make a backup copy of
the original disk. After making a backup copy, keep the
original disk in a safe place.
NOTE: Depending on your Windows ® system files, the PC
may require rebooting. In this case, repeat the installation
from the beginning.
q Boot up Windows.
• Quit all applications when Windows is running.
w Insert backup disk into the appropriate floppy drive.
e Select ‘Run’ from the [Start] menu.
r Type the setup program name with full path name, then
press the [Enter] key. (A:\SETUP [Enter])
t Follow the prompts.
y Program group ‘CS-2800’ appears in the ‘Programs’ folder
of the start menu.
76
16
CS-2800 CLONING SOFTWARE
optional CS-2800 and OPC-478
IC-2800H
To [430(440)
MHz SP]
to an RS-232C
port
DB9 female plug
(incl. level converter circuit)
Personal
computer
OPC-478
■ Connections
All cloning operations are performed from
the computer’s keyboard—the operation re-
quired on the transceiver side is:
while pushing the microphone [UP] switch +
the 4th switch from the top on the left side,
push [POWER] on the controller.