6 troubleshooting – IBM Partner Pavilion 9013RF User Manual

Page 18

Advertising
background image

14

6 Troubleshooting

If you are experiencing problems with your keyboard or mouse please check the
following:

1.

Take out the receiver’s connector and check both the receiver’s mouse and
keyboard plug for possible broken pins. If the plugs appear normal then
reinsert the plugs into their respective connectors on your PC.

2.

Make sure the mouse plug is inserted in the mouse connector on your PC
and the keyboard plug is inserted into the keyboard connector on your PC.
Compare the icons on both the cable and backside of your PC if necessary.

3. Check to see

if the batteries in the keyboard and mouse are installed

correctly. Make sure the polarity of the batteries corresponds with the
polarity signs in the battery compartment.

4.

Replace the batteries to make sure the batteries are not low in power. After
replacing the batteries of keyboard or mouse, please also remember to set
the ID. There is no need to reset all the ID’s. Simply reset one of them.

5. Check to see

if the channel switch for the receiver, keyboard and mouse

are

set to the same channel. Try the alternate channel for the receiver,

keyboard and mouse in case the initially selected channel appears to work
improperly, other devices in the vicinity of the receiver may cause
interference.

6. Please remember to set the ID when your keyboard kits do not work

properly.

7. It is strongly recommended to place the receiver in front of the monitor in

order to prevent signal disturbance from the monitor.

8. If your PC system’s BIOS setup has options for the keyboard or mouse -

make

sure they are set to default settings. If you are not familiar with the

BIOS, refer to your PC’s manual for more information.

9. If you have problems using the sleep button - make sure that the power

management in your PC has been enabled both in the BIOS and in
Windows. For more information on your PC’s BIOS settings - refer to your
PC’s manual. For more information on how to enable the power
management features

in

Windows, refer to your Windows manual.

Advertising