IBM Partner Pavilion 9013RF - Manual (Page 9)

5
ID Setting
This wireless keyboard kits contains 2 channels, and each channel contains 255
sets ID. This extra ID-recognition function helps to protect against interference
from other RF keyboards in the same environment.
# The word CONNECT labels the ID button on each unit.
# The LED under ID button of receiver shows connecting condition.
Step 1: Press the ID button on the top of the receiver once.
ID Button
Step 2: Press the ID button on the bottom of the mouse once.
ID BUTTON
CHANNEL SWITCH
Step 3: Press the ID button on the bottom of the keyboard once.
CH2 CH1
ID Button
Remarks:
1. You must follow the procedure above to set the ID of receiver, mouse and
keyboard.
Once the receiver ID button is pressed you have 35 seconds to
complete the entire process, or you will need to begin again.
2. Once the keyboard and receiver are plugged in, the yellow receiver light will
flash. Once the ID is set, it will remain steadily lit.
ID Button of Receiver
ID Button of Mouse
ID Button of Keyboard