Intel SYS7180VE - Manual (Page 24)

CHAPTER 3 - BIOS SETUP
SYS7180VE User’s Manual 41
Description Choice
USB Keyboard Support
Select Enabled if your system contains a
Universal Serial Bus (USB) controller and
you have a USB keyboard.
AC’97 Audio
Select Enabled to use the audio capabilities
of your system. Most of the following fields
do not appear when this field is Disabled.
Init Display First
Initialize the AGP video display before
initializing any other display device on the
system. Thus the AGP display becomes the
primary display.
Onboard CNR LAN control
Select Enabled to active the onboard
10/100-LAN controller, select Disabled to
turn-off the onboard 10/100-LAN controller
when you do not want to use this function.
IDE HDD Block mode
Block mode is also called block transfer,
multiple commands, or multiple sector
read/write. If your IDE hard drive supports
block mode (most new drives do), select
Enabled for automatic detection of the
optimal number of block read/writes per
sector the drive can support
CHAPTER 3 - BIOS SETUP
42 SYS7180VE User’s Manual
Description Choice
sector the drive can support.
Onboard FDC Controller
Select Enabled if your system has a floppy
disk controller (FDC) installed on the system
board and you wish to use it. If you install
and-in FDC or the system has no floppy
drive, select Disabled in this field.
Onboard Serial Port 1
Select a logical COM port name and
matching address for the first and second
serial ports. Select an address and
corresponding interrupt for the first and
second serial ports.
Onboard Serial Port 2
Select a logical COM port name and
matching address for the first and second
serial ports. Select an address and
corresponding interrupt for the first and
second serial ports.
Onboard Parallel Port
Select a logical LPT port name and matching
address for the physical parallel (printer) port