Intel SYS7180VE - Manual (Page 4)

CHAPTER 1 – Introduction
SYS7180VE User’s Manual 1
Chapter 1 Introduction
1.1 Specification
Processor Support Intel® Pentium TM 4 CPU up to 3.06 GHz
Support Intel® Celeron TM CPU up to 2.60 GHz
Support Intel® Celeron®D TM CPU up to 2.80 GHz (Prescott core)
Chipset Intel®82845GV chipset supports 400/533MHz FSB
Memory Two 184-pin DDR DIMMs socket, up to 2GB of 266/333MHz
DDR SDRAM
BIOS Award 4Mbit PnP flash BIOS
VGA Integrated in 845GV, AGP4X
Share memory up to 64MB with system main-memory
LAN LAN1: Intel® 82562ET Ethernet controller, supports 10/100M
Base-T
LAN2: (optional)Intel®82540EM Ethernet controller, supports
10/100/1000 Base-T
Wake On LAN support
USB Four USB ports, Hi-speed USB 2.0
Super I/O Mini-DIN: 1x PS/2 keyboard/mouse connector
RJ-45: 10/100/1000Mb Ethernet connector
Female DB-15: VGA connector
Box-header: 2* Serial port (2x5Pin);
1*FDD (2x17Pin); 2* EIDE (2x20Pin);
Pin-header: 1*Parallel port (2x13Pin)
Watchdog System reset or non- maskable interrupt software programmable
time I interval and jumper selectable (64-level)
Operating temperature 0 C ~60 C
Relative humidity 10%~90% non-condensing at temperature of 40BC or
104BF
1.2 Check List
Please check that your package is complete and contains the items below. If you
discover damaged or missing items, please contact your dealer.
SYS7180VE CPU card
Utility CD for SYS7180VE
Installation Guide
IDE cable *2
FDD cable *1
CHAPTER 1 – Introduction
2 SYS7180VE User’s Manual
PS/2 1 to 2 adapter *1
Com extension cables with bracket *1
Com, Printer extension cables with bracket *1
+12V power cable *1
USB cable *1 Special for SYS7180VE
Jumper Short Pin: 6 pcs
1.3 Description
The SYS7180VE is a motherboard based on Intel 845GV chipset and is fully
designed for PC environment. It features socket 478 compatible with Intel’s processor.
This card accommodates up to 2GB of DDR memory.
The SYS7180VE comes with on board CPU temperature sensor to protect your
processor from overheating (Winbond W83627HF chipset). Wired for Management
(WFM) 2.0 specification compliance.
The SYS7180VE has a LAN connector that uses Intel ICH4 integrated with Intel
82562ET (AOL & 10/100) controller.
1.4 Power Requirements
Your system requires a clean, steady power source for reliable performance of the
high frequency CPU on the SYS7180VE Industrial CPU card, the quality of the power
supply is even more important. For the best performance makes sure your power supply
provides a range of 4.75 volts minimum to 5.25 volts maximum DC power source.
Power Consumption
For typical configurations, the CPU card is designed to operate with at least a 200W
power supply. A higher-wattage power supply should be used for heavily-loaded
configurations. The power supply must meet the following requirements:
Rise time for power supply: 2 ms to 20 ms
Minimum delay for reset to Power Good: 100 ms
Minimum Power down warning: 1 ms