Wiring connections, To install the player – Insignia NS-M10OHD User Manual

Page 6

Advertising
background image

6

www.insignia-products.com

Wiring connections

To install the player:

1 Move the polarity switch fully to the correct

polarity of your vehicle’s power supply
system. To determine your vehicle’s polarity,
see its user guide or call the dealer.

If your vehicle’s power supply system is
negative, set the switch to -.

If your vehicle’s power supply system is
positive, set the switch to +.

2 To prevent short circuits, remove the key from

the ignition and disconnect the battery from
the vehicle.

3 Disconnect the original dome light.

4 Attach the metal mounting plate to the roof

using the ST 4.2×25.4, ST 4.2×38.1, or
ST 4.2×50.8 screws.

5 Pull the original dome light power wire and

power/signal cable through the original dome
light opening.

6 Place the rubber gasket on the DVD player.

7 Connect the input and output cables.

8 Connect the wire harness in the following

order: ground lead, battery lead, ACC lead,
and door lead.

Item

Description

AV IN2

Secondary input for external audio/video
sources.

AV OUT

Output for the player’s audio/video to
external displays or sound systems.

AV IN1

Primary input for external audio/video
sources.

Battery lead +

Connect this to the positive terminal lead
of the car battery.

ACC power lead

Connect this to the engine accessory
power lead.

Ground lead

Connect this to a negative terminal lead of
the vehicle battery.

Door lead

Connect this to the door sensor lead, so
the player’s dome light can be turned on
and off by opening or closing the door.

FM antenna wire

This wire sends the FM transmitter signal
to an FM receiver.

Polarity switch

Slide this switch fully to the correct
polarity of your car’s power supply
system.

AV

I

N

1

AV

I

N

2

AV

O

U

T

FM Antenna

ACC lead (red)

Ground lead (black)

Door lead (green)

Polarity switch

Battery lead + (yellow)

Caution

Do not move the position of the switch after
installing the player, or the player may be
damaged.

Caution

Do not cover the original dome light opening.

Six ST 4.2×25.4, ST 4.2×38.1, or
ST 4.2×50.8 screws

NS-M10OHD_FINAL4.fm Page 6 Wednesday, March 29, 2006 4:12 PM

Advertising