IBM P275 - Manual (Page 15)

13
US
x x x x EXPERT mode
You can make additional adjustments to the color in greater detail
by selecting the EXPERT mode.
1 Press the button.
The menu appears on the screen.
2 Press the m/M buttons to highlight COLOR and
press the button.
3 Press the m/M buttons to select the R (red), G
(green), or B (blue) and press the button. Then
press the </, buttons to adjust the input signal
for both GAIN (6) and BIAS ( ).
If you want to reset the EXPERT adjustments, select
0 (RESET) in COLOR menu. Then select OK in the RESET
window.
x x x x sRGB mode
The sRGB color setting is an industry standard color space
protocol designed to correlate the displayed and printed colors of
sRGB compliant computer products. To adjust the colors to the
sRGB profile, simply select the sRGB mode in the COLOR
MODE ( ) menu of the OPTION ( ) menu.
However, in order to display the sRGB colors correctly (
γ = 2.2,
6500K), you must set your computer to the sRGB profile. If you
select this mode, you cannot operate the CONTRAST/BRIGHT
menu adjustments.
Note
Your computer and other connected products (such as a printer), must be
sRGB compliant.
Restoring the color from the PRESET, VARIABLE,
or sRGB modes (COLOR RETURN)
The colors of most display monitors tend to gradually change
brilliance over several years of service. The COLOR RETURN
feature found in the PRESET, VARIABLE, and sRGB menus
allows you to restore the color to the original factory quality
levels. The explanation below explains how to restore the
monitor’s color from the PRESET mode for example.
First, select the PRESET, VARIABLE, or sRGB mode in the
OPTION menu (page 12).
1 Press the button.
The menu appears on the screen.
2 Press the m/M buttons to highlight COLOR and
press the button.
The COLOR menu appears on the screen.
3 Press the m/M buttons to highlight (COLOR
RETURN). Then press the button.
4 Press the m/M buttons to select OK.
The picture disappears while the color is being restored (for a
few seconds). After the color is restored, the picture reappears
on the screen.
Notes
• Before using this feature, the monitor must be in normal operation
mode (green power indicator on) for at least 30 minutes. If the monitor
goes into power saving mode, you must return the monitor to normal
operation mode and wait for 30 minutes for the monitor to be ready.
You may need to adjust your computer’s power saving settings to keep
the monitor in normal operation mode for the full 30 minutes. If the
monitor is not ready, the following message will appear.
• The monitor may gradually lose its ability to perform this function due
to the natural aging of the picture tube.
45
COLOR
R
G
B
R
G
B
1 6 0 0 x 1 2 0 0 / 8 5 H z
: EXPERT
COLOR
s
: /
RGB
1 6 0 0 x 1 2 0 0 / 8 5 H z
: sRGB
COLOR
RETURN
OK
CANCEL
COLOR : PRESET
1 6 0 0 x 1 2 0 0 / 8 5 H z
COLOR
RETURN
COLOR : PRESET
1 6 0 0 x 1 2 0 0 / 8 5 H z
AVA
A F T E R
WARM UP LABLE I