Selecting the input signal, Customizing your monitor, Navigating the menu – IBM P275 User Manual
Page 8
6
US
Selecting the input signal
You can connect two computers to this monitor using the video
input connectors. To select one of the two computers, use the
(input) switch.
Slide the
(input) switch.
The selected video input connector appears on the screen for 3
seconds.
“INPUT 1” or “INPUT 2” appears on the screen.
Note
If no signal is input to the selected video input connector, NO SIGNAL
appears on the screen. After a minute, the monitor enters the power saving
mode. If this happens, switch to the other video input connector.
Customizing Your Monitor
You can make numerous adjustments to your monitor using the
on-screen menu.
Navigating the menu
x
x
x
x Using the
,
m/M, and </, buttons
1
Display the menu.
Press the
button to display the menu on the screen.
2
Select the menu you want to adjust.
Highlight the desired menu by pressing the
m/M buttons.
Then press the
button.
3
Adjust the menu.
Press the
</, buttons to make the adjustment, then press
the
button to activate the adjustment.
If you want to select another menu:
Press the
m/M buttons to select
and press the
button to
exit the menu.
4
Close the menu.
Each time you select
and press the
button, the menu
exits. If no buttons are pressed, the menu closes automatically
after about 30 seconds.
EX
CONTRAST
I T
85
1 6 0 0 x 1 2 0 0 / 8 5 H z
b
b
b
(continued)