Icom AT-141 - Manual (Page 6)

2
3
INSTALLATIONS
2001 NEW
■ Installation outline
q Connect a control cable and 4-conductor shielded
cable.
• Refer to “Control cable” below.
w Connect and solder the PL-259 connector to the
coaxial cable.
• Refer to p. 4 “PL-259 connector.”
e Mount the AT-141 in the desired location.
• Refer to p. 4 “Mounting.”
r Connect the control and the coaxial cables be-
tween the transceiver and the AT-141.
• Refer to p. 5 “Cable connections.”
t Connect an antenna, ship’s ground or counter-
poise.
• Refer to p. 1 “Antenna for ship” and p. 2 “Ground and
counterpoise.”
■ Control cable
Between the AT-141 and HF marine transceiver, con-
nect 4 control signal lines as shown below. To prevent
RF feedback, use a 4-conductor shielded cable. Con-
nect the shield line to the [GND] terminal on the trans-
ceiver. Icom offers 10 m (32.8 ft) long optional control
cables as at right. OPC-1465 : for IC-M801E
Refer to p. 6 “Terminal information” for details.
D When connecting to Icom IC-M801E
[GND]
To AT-141
[ANTC] : Black
[13.6] : Red
[STAR] : White
[KEY] : Green
Use the optional OPC-1465, or assemble the desired length 4-con-
ductor shielded cable and the connector kits supplied with the trans-
ceiver and the tuner.
[ANTC] : Black
[13.6] : Red
[STAR] : White
[KEY] : Green
To transceiver
[GND]
AT-141_0.qxd 05.12.1 11:06 Page 3